Wooden Camera 175500 Manuel télécharger pdf

UNIVERSAL LENS SUPPORT (19mm/15mm Studio)

ROLLING Y BRACKET

1/4-20

TIGHTENING

KNOB

EXTENSIONS

SMALL & LARGE

19mm/15mm STUDIO

Included:

3/8-16

NOTE: LENS SUPPORT comes with factory installed

3/8-16 SCREW. To remove and install additional

adapters follow the steps below.

1. Select LENS SUPPORT, loosen thumscrew, locate and

loosen TIGHTENING KNOB to remove 3/8-16.

2. To switch from19mm to 15mm STUDIO, loosen and

slide THUMBSCREW to desired position and re-tighten,

adjust the ROD CLAMP size by turning the

THUMBWHEELS.

3. Choose desired adapter type. For example: select and

tighten Y BRACKET to LARGE EXTENSION and install as

shown below.

4. Select LENS SUPPORT, insert Y BRACKET, insert

TIGHTENING KNOB, adjust left or right position and up

or down to proper lens height, tighten THUMBSCREW

until vertical & horizontal position is secure.

THUMBSCREW

THUMBWHEEL

4. Place LENS SUPPORT on RODS and tighten using

THUMBWHEELS.

5. Unlock THUMBSCREW, center position under LENS

FOOT and re-tighten THUMBSCREW.

RODS

THUMBWHEEL

LENS

LENS FOOT

LARGE EXTENSION

Page 1

UNIVERSAL LENS SUPPORT (19mm/15mm Studio)© Wooden Camera, Inc. 2011-2014ROLLING Y BRACKET1/4-20TIGHTENINGKNOBEXTENSIONSSMALL & LARGE19mm/15mm STUD

Pas de commentaire

Wooden Camera 175500 Manuel